Including ZWave Node

Press the include button on your device...



Included node: {{ozw_node_id}}
{{ozw_node_desc}}

Excluding ZWave Node

Press the exclude button on your device...



Excluded node: {{ozw_node_id}}

Outside Temperature Sensor:
Command:





You can retreive old month records by running SBFSpot/SMASpot with commandline parameter -v -amXX,
where XX is the amount of months you would like to retreive, for example:
./SBFSpot -v -am12 , this will retreive up to 2 years from now.

This process can take a while, when pressing the above button, please wait until the dashboard is shown again!.

Nodes
  • Include Node
  • Include Node Secure
  • Exclude Node
  • Heal network
  • Groups & Network
  • Soft reset controller
  • Hard reset controller
  • Receive configuration from other controller
  • Send configuration to other controller
  • Transfer primary role
  • Start User Code Enrollment
  • User Code Management
  • Download Configuration File
  • Control Panel
NodeID Name Description Last Seen Enable Polling Status
Update    Delete Refresh


Configuration


User Codes

Code Value Action
Refresh

Please note, removing a code can take a while on battery operated devices.
To quickly force the hardware to remove the code (after pressing the remove button)
Use the tamper switch on the back to wake up the device.

Nodes
NodeID Name Sketch Name Version Childs Last Seen
Update    Delete Refresh


Childs
ChildID Type Name Values Ack Last Seen
Update    Delete Refresh

Nodes
ID Name Mac Address
Update    Delete Clear

Add

Settings
 (Seconds)
 ()
Apply Settings

Nodes
ID Name IP Address Timeout
Update    Delete Clear

 (Seconds)
Add

Settings
 (Seconds)
 ()
Apply Settings

Nodes
ID Name IP Address Port
Update    Delete Clear

Add

Settings
 (Seconds)
 ()
Apply Settings

Nodes
ID Name IP Address Port
Update    Delete Clear

Add

Settings
 (Seconds)
 ()
Apply Settings

Devices
ID Name Mac Address
       
       
     
     
     
     
     
     



868.30MHz 868.30MHz FSK 868.35MHz 868.35MHz FSK 868.95MHz
         
     

You can only enable protocols for the same frequency!



Note: Any change will take effect after restarting Domoticz!


Hardware:




Hardware:


Meter 1:


Meter 2:


Meter 3:


Meter 4:


Meter 5:



Hardware:






Idx Name Enabled Type Address Port Data Timeout
Update    Delete










Register on Bridge



Select the Topic('s) Domoticz will use to publish outgoing messages.
Flat - publish outgoing messagen on topic domoticz/out.
Hierarchical - publish outgoing messagen on topic domoticz/out/${floorplan name}/${plan name}.
Combined - Use both Flat and Hierarchical topic schemes.
None - disable outgoing messages.

Note that Hierarchical only reports sensor updates for sensors that are placed on a floorplan/plan.

Add